Acom-1200S  Hf linear

even bellen voor levertijd!!!!!

Standard Frequency Coverage

  • All amateur bands 1.8-54 MHz;
  • Extensions and/or changes on request;

Rated Output Power

  • 1000 W ±0.5 dB, PEP or continuous carrier, without mode limitation;

Intermodulation Distortion (IM3)

  • Better than 31 dB below rated PEP;

Harmonic and Parasitic Emissions Output Suppression

  • Better than 60 dB (65 dB typically);

Input and Output Impedances

  • Nominal value: 50 Ohm unbalanced, UHF (SO-239) type connectors;
  • Input circuit: Broadband, SWR below 1.2 (1.1 typically), 1.8-54 MHz continuous range without retuning or switching;
  • RF bypass path: SWR - below 1.1, 1.8-54 MHz;
  • Acceptable SWR at the output load (the antenna): up to 3 with proportional power reduction and up to 1.5 for full output power;

RF Power Gain

  • 14 dB ±1 dB (typically 40 W for 1000 W output power);

Mains Power Supply Voltage

  • 100-240 VAC, ±10%, 50-60 Hz, Single phase;
  • Below 200 VAC the output power is reduced to 500 W;

Mains Power Consumption at Full Output Power

  • Power factor of 0.95 or higher;
  • Up to 2100 VA at rated output from 200/240 VAC mains supply;
  • Up to 1100 VA at 500 W output from 100/120 VAC mains supply;

Mains Power Consumption in Low Energy (Waiting) Mode

  • Less than 1 VA;

Receive / Transmit Control

  • KEY-IN - Phono RCA connector
    • Voltage applied to the transceiver keying output - up to +12 V;
    • Closed-circuit current flow to the transceiver keying output - up to 6 mA;
  • KEY-OUT - open-drain Phono RCA connector
    • Output resistance: not more than 120 Ohm;
    • The maximum allowable open-circuit voltage coming from external devices connection: +50 V;
    • Maximum allowable closed-circuit current flow by external devices: 20 mA;
  • Minimum required time of sequencing between sending a request for transmitting (KEY-IN "ground on transmit" signal) and applying RF drive power at RF INPUT connector for safely switching receive to transmit: 10 ms.

Safety and Electromagnetic Compatibility

  • Complies with CE safety and electromagnetic compatibility requirements, as well  as with the US Federal Communications Commission (FCC) regulations;

Size & Weight (operating, excluding connected cables and opened tilt foot bar)

  • WxDxH: 372x418x162 mm, 16 kg (14.7x16.5x6.4 inches, 35.3 lbs.);

Shipping Size & Weight

  • WxDxH: Approx. 550x540x360 mm, 19.0 kg (21.7x21.3x14.2 inches, 41.9 lbs.);
  • Please, contact us for shipment details;

Operating environments

  • Temperature range: -10 to +40 degrees Celsius (14 degrees F to 104 degrees F);
  • Relative air humidity: up to 95% @ +35 degrees Celsius (95 degrees F);
  • Height above sea level: up to 3050 m (10000 ft) without output deterioration.

Geef beoordeling

Note: HTML-code wordt niet vertaald!
    Slecht           Goed

Acom-1200S Hf linear

  • Merk: Acom
  • Model: Acom-1200S
  • Beschikbaarheid: Op voorraad
  • € 3.395,00

  • Excl. BTW: € 2.805,79

Gerelateerde producten

Acom 1000 HF Linear  1Kw  Op VOORRAAD

Acom 1000 HF Linear 1Kw Op VOORRAAD

In STOCK!!!!!!!--------------------------------------------Acom 1000 Amplifier 160-10m+6m+Warc Freq..

€ 3.145,00 Excl. BTW: € 2.599,17

ACOM 1010 | HF Linear Amplifier

ACOM 1010 | HF Linear Amplifier

ACOM 1010 | HF Linear AmplifierBel voor levertijdFrequency Coverage All amateur bands in the 1.8-..

€ 2.195,00 Excl. BTW: € 1.814,05

ACOM 2000A | Automatic HF Linear Amplifier

ACOM 2000A | Automatic HF Linear Amplifier

ACOM 2000A | Automatic HF Linear Amplifiervraag naar levertijdFrequency Coverage All amateur bands ..

€ 5.994,34 Excl. BTW: € 4.954,00

Tags: Acom-1200S